Feb 25, 2018

Construction Begins On FES Heat Storage For Wind Energy


Over a period of three years, Siemens Gamesa Renewable Energy has been doing R&D activities on converting energy to heat in rock fill at a testing unit in Hamburg. Now the company will convert its findings into a real scale project.

Siemens Gamesa is installing the first full scale “Future Energy System – FES” on the Trimet SE aluminum smelter site in Hamburg-Altenwerder. It will feature about 1,000 tons of rock fill, which will be able to provide 30 MWh of electric energy at temperatures of 600 degrees C. Via a steam turbine, the heat can be re-converted into electricity. A generator rated at 1.5 MW will produce energy for up to 24 hours. Within this period, the system can supply energy equivalent to the consumption of 1,500 average German households, or it could charge the batteries of approximately 50 electric cars. The local utility Hamburg Energie GmbH is a partner. The company will test the commercial opportunities of the storage technology in the energy markets. With the start of construction, Siemens Gamesa reaches a milestone in the development of a key technology in the context of the energy transition.

In times of sunny weather and high wind conditions, renewable energies are available in large amounts — often the feed-in exceeds the grid capacities. Storage systems can act as a buffer between times of overload and weak production periods, which happen at slack periods and darkness. But most storage technology offers limited capacities or are not cost-competitive. The Siemens Gamesa solution under development offers a highly economic approach in storing energy.

Image 1

After having been converted to heat in rock fill, excess wind energy is stored and protected with an insulated cover. When there is a need for additional electricity, a steam turbine converts the heat energy back to electricity. The simple principle of this storage combines proven components to an innovative setup: For the conversion process of electricity into a hot air stream, it uses fans and heating elements out of mass production. The same applies to the re-conversion: Via a highly dynamic Siemens steam boiler, a standard steam turbine generates electricity at the end of the process chain.

The focus of Siemens Gamesa’s R&D activities was on the insulated container to house the rock fill, which is the virtual battery and the core innovation. In the research project, the team has explored the thermodynamic principles to receive a high efficiency in all processes related to the transmission to heat. A scientist of Technical University Hamburg-Harburg (TUHH) supports the project by modeling the processes inside the storage unit, which results in principles for thermodynamic calculations of the processes. All learnings will now be incorporated in the real scale FES. One of the key findings was an optimized shape of the container with the rock fill. The design of the storage container of the new project reflects this: Its round-bodied shape will have a decreasing diameter at both ends where the inflow and the outflow openings are positioned. The ferroconcrete giant will have a content of 800 cubic meters of rock fill with a mass of 1,000 tons and will be covered with a meter-thick layer of thermal insulation.

Siemens Gamesa is expecting a construction time of approximately one year for the new FES system. The work in Hamburg-Altenwerder started in December with commissioning planned for spring 2019. After comprehensive testing, the new storage system will operate in collaboration with Hamburg Energie GmbH. 

Source: Siemens Gamesa

For more information, go to www.siemensgamesa.com


Comments

You must Log In to comment.

Be the first to comment!